Installation Guide

NOTE
Select a suitable location that is not susceptible to moisture and is away from drapes,
fireplace near an existing outlet.
Ensure the power cord is not installed so that it is pinched or against a sharp edge
and ensure that the power cord is stored or secured to avoid tripping or snagging to
reduce the risk of fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes and
other applicable regulations to reduce the risk of fire, electric shock and injury to
persons.
electric shock or injury to persons, always use a licensed electrician.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire,
This heater is for use on 120 volts.
See figure 1 for grounding instruction.
The cord has a plug as shown at A in
Figure 1. An adapter as shown at C is
available for connecting three-blade
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle is
available.
WARNING
SITE SELECTION AND PREPARATION
Figure 1
• The fireplace insert comes completely assembled and wired. Some tools may be
required to prepare the site and install the trim.
• The dimensions of the fireplace insert are 32.5” wide x 24” high x 12” deep.
• You should allow 1/4” around the fireplace insert for ease of installation.
• This fireplace does not require any venting.
!
5
This section provides easy step by step instructions for selecting a location and
preparing the site to install the fireplace into any Real Flame® Grand fireplace mantel.