Installation Guide

OPERATION AND FEATURES
Using the Remote Control
Using the Control Panel
6
When turned OFF the embers of the log set will not immediately go out. This is a
designed feature to represent the embers of the fire slowly fading out.
!
NOTE
NOTE
Power
This will turn the
unit ON/OFF.
Adjust Brightness
This function will
cycle through the
five dierent levels
of flame brightness.
Timer/Dynamic Embers
This will allow you to set
the automatic shuto
on the fireplace. Hold
for 5 seconds to switch
to Dynamic Embers.
This function will make
the embers of the fire
automatically glow
dimmer or brighter
creating a realistic fire
eect. Hold 5 seconds
to return to Timer.
Adjust Flame
This allows you to
change Flame Color.
Adjust Heater
This function will cycle through the
dierent temperature levels of the
heater. Hold 5 seconds to switch
readout between °F and °C.
Ambient Light
This will turn the
ambient light above
the logs ON/OFF.
Power
This will turn the unit ON/OFF. When turned
back ON, the system will recall the last heat
setting used.
Brightness
This allows you to raise or lower the level of
flame brightness.
Dynamic
Embers
This function will make the embers of the fire
automatically glow dimmer and brighter, creating
a realistic fire eect.
Ambient
Light
This will turn the ambient light above the
logs ON or OFF.
Adjust Flame
This allows you to change the flame color
between six dierent options.
Adjust
Temperature
This allows programming of the thermostat. The
firebox can be used without the heater if desired;
cycle through the function until no temperature is
displayed. Press and hold the UP arrow for
five seconds to switch temperature readout
from °F to °C and back.
Timed
Shut-O
This allows you to set the fireplace to
automatically shut OFF after the amount of time
displayed on the screen. Timer can be set for 30
minutes up to 9 hours.
!
!