Instructions / Assembly

ASSEMBLY INSTRUCTIONS
3. Place the filler material into the burner pan by hand. To avoid clogging the burner with dust
do not dump the bag into the burner pan. Position the filler across the burner pan to a level
that is 1 inch (2.54 cm) above the burner tube. Make sure you do not block the igniter housing
with the filler material to ensure proper ignition and operation.
If using glass filler, Real Flame suggests first placing a layer of lava rock in the burner pan
to improve airflow.
Filler Material Warning
• Do not overfill the burner area with rock or glass filler; use only the specified amount. The
depth of the filler should not be more than 1 inch (2.54 cm) above the burner tube. Only
Real Flame filler products have been certified and tested for safe use with this Real Flame
fireplace. Using other filler material may result in increased popping and cracking or increased
carbon monoxide emissions.
• Do not light or use this
fireplace if the filler is wet. Ensure filler is completely dry before lighting.
Intense heat can c
ause wet filler to explode and hit someone causing property damage,
serious injury, or death.
• Keep away from the fireplace for at least 20 minutes during initial start-up as filler could
retain moisture from manufacturing and shipping.
7
Install the AA battery as shown in the diagram below.2.
Igniter Housing
Do not block
+
_
1.
With the fire table upside down.
Install the feet by screwing them into the holes located in
the corners of the unit. Place the hose guide over the hose and fix with the provided screws.
Be careful not to damage hose while installing hose guide.