Replacement Part List

8
by pushing right on the safety lock(Fig.9).
3. Snap the desired nozzle into the spray
lance tight.
To disconnect a nozzle from the spray lance
once the cleaning job is complete:
4. Turn off the pressure washer and shut off
the water supply.Pull the trigger to release
water pressure.
5. Engage the safety lock on the trigger
handle by pushing right on the safety
lock(Fig.9).
6. Remove the nozzle from the spray lance.
WARNING! Do not make changes to the
nozzle while the trigger is engaged. Doing
so could result in damage to the pressure
washer or injury to the user.
Working with detergents
When cleaning with the pressure washer,
some cleaning tasks can be solved with
water alone, but for most tasks cleaning with
detergent allows for more effective dirt
removal.
WARNING! Use only detergents designed
for Pressure Washers. DO NOT USE
household detergents, acids, alkaline
solutions, bleaches, solvents, flammable
material, or industrial grade solutions.
These could damage the pressure washer.
Many detergents may require mixing prior
to use. Prepare the cleaning solution as
instructed on the solution bottle.
1.Remove the cap from the detergent
bottle and fill it with detergent designed
specifically for use with pressure washers
(Fig. 10).
2. Install the Soap nozzle (black) on the spray
gun.
CAUTION! Always test the detergent in an
inconspicuous area before use.
3. Turn on the pressure washer. Pull the trigger
to operate the unit. The liquid detergent will
automatically mix with water and be discharged
through the nozzle.
4. Apply detergent from the bottom to the top of
the dry surface to be cleaned.
NOTE: Wetting the surface first is not
recommended as it dilutes the detergent and
reduces its cleaning ability.
5. Allow the detergent to remain on the surface
for a short time before rinsing. Do not allow the
detergent to dry on the surface.
CAUTION!
Damage may occur to painted
surfaces if the detergent is allowed to dry on the
surface. Wash and rinse a small section at a
time. Avoid working on hot surfaces or in direct
sunlight.
6. When you have finished using the
detergent injection system, insert the bottle
detergent with fresh water. Siphon water at
low-pressure for one minute to rinse the
bottle until it is thoroughly cleaned.
CAUTION!
Failure to follow these cleaning
instructions will cause the injection system to
become clogged and inoperable.
Pressure washer
detergent
Fig.10
Fig.10