Replacement Part List

7
NOTE: Check that the filter is fitted in the
garden hose adaptor and that it is not clogged
up.
8. Check that the electrical supply voltage and
frequency(Volt/Hz) correspond to those
specified on the pressurewasher rating
plate. If the power supply is correct, youmay
now plug the pressure washer into the power
outlet (Fig. 10).
NOTE: The GFCI may need to be reset when
first plugged into the electric outlet. Press the
"Reset" button until thepower light indicator
on the GFCI illuminates.
Operation
IMPORTANT!
This pressure washer is
equipped with a micro-switch sensitive to
water flow. This Total Stop System (TSS)
senses water flow in the pump. When the
trigger is released, water stops flowing
through the pump. The TSS then
automatically turns the motor off to protect the
pump from overheating, thus saving energy
and prolonging pump life.
CAUTION! The trigger gun and lance is
affected by a thrust during operation,
therefore always hold it firmly with both hands.
Point the spray gun at the ground.
Check that the machine is in upright position.
Do not place the machine in high grass!
1. Turn the water supply tap on completely.
2. Release the trigger lock.(Fig.9) .Press the
trigger for a few seconds until water flow is
steady. This will allow air to escape and
discharge any residual pressure in the hose.
Using the nozzles
Before beginning any cleaning task, determine
the best nozzle for the job. Each of the
nozzles has a different spray pattern.
CAUTION! NEVER change nozzles without
locking the safety lock on the trigger handle.
WARNING! High-pressure jets can be
dangerous if subject to misuse. The jet must
not be directed at persons, pets, live electrical
equipment, or the appliance itself.
To connect a nozzle to the spray lance:
1. Turn off the pressure washer and shut off the
water supply. Pull the trigger to release water
pressure.
2. Engage the safety lock on the trigger handle
Reset
Power light indicator
GFCI
Fig.8
Fig.9