Assembly and Installation Instructions

ASSEMBLY AND INSTALLATION INSTRUCTIONS
2-DRAWER KITS
2
3
A
E
H
H
E
D
I
B
C
2.1
2.2
Position Small Drawer Front (C) on each Small Drawer (A) and secure with two 1.2" Screws (J).
Position Large Drawer Front (D) on Large Drawer (B) and secure with two 1.2" Screws (J).
3.1
3.2
For each Drawer, position Drawer Slide (E) against Drawer with
front end of Slide flush and square with rear side of Drawer Front,
then secure with two 0.445" Screws (H) at locations shown. Repeat
for second Drawer Slide (E).
If desired, install Drawer Knob (H) on each Drawer: Using center hole in
Drawer as a guide, use Drill (L) to drill a pilot hole through Drawer Front.
Install Drawer Knob (H) on Drawer and secure with one 1.5" Screw (K).
Alternatively, you can install a 94mm Drawer Pull (purchased separately)
using the holes to the left and right of center
H
H
G
H
I
I
I
K
SLIDE RELEASE
NOTE: Drawer Slides (E) and Shelf Slides
(F) are shipped assembled. Lift
Slide Release to separate Drawer
Slide from Shelf Slide.