OWNER’S MANUAL 48” STAINLESS STEEL TABLE
PARTS LIST Your 48” Stainless Steel Table should include the following parts. Please inspect box contents to ensure you have received all components.
ASSEMBLY INSTRUCTIONS STEP 1 Lay the TABLE TOP (A) upside-down on a smooth flat surface. Insert LEGS (C) into the round slots on the bottom of the TABLE TOP (A). Make sure LEGS (C) are fully inserted into the TABLE TOP (A). A (1) C (4) E (4) F (1) You will insert and tighten the HEX SCREWS (D) in Step 3. C A STEP 2 Slide the SHELF (B) over each LEG (C) to the desired height. Using the provided HEX KEY (F), tighten the HEX SCREW (D) into the SHELF (B).
ASSEMBLY INSTRUCTIONS STEP 3 Use the HEX KEY (F) to tighten the HEX SCREW (D) for each LEG (C) into the TABLE TOP (A). D (4) E (4) F (1) Turn the HEX KEY (F) as far clockwise as possible, take out the HEX KEY (F), reposition, reinsert, and turn as far clockwise as possible again until the HEX SCREW (D) is securely in place. Place the SCREW CAP (E) over each HEX SCREW (D). Turn the Table right-side up and adjust Feet Levelers until the Table is stable and level.
SERVICE PARTS LIST (w/Casters)
WARNINGS 1. Read and understand all instructions. Failure to follow all instructions may result in injury and/or damage. 2. (Mobile Option) Use the provided caster wrench to tighten casters completely. Failure to do as instructed could result in the caster stem breaking thereby causing the shelving rack to collapse. 3. The warnings, cautions, and instructions discussed in this manual cannot cover all possible conditions or situations that may occur.
