Safety Instructions
9
PRO Mode (Custom)
The PRO Mode allows you to create a fully customized program that’s unique to you.
• You can use the Pretreatment program or you can choose from four inflation cycles:
Sequential, Isolation, Wave, or Flow.
• During your treatment, you can change the treatment parameters, but you can’t change
the selected inflation cycle and can’t turn the pre-selected program ON/OFF.
Pretreatment (See Figure 3)
• Pretreatment treats the proximal areas first.
• A specific pattern is applied, and the duration varies according to garment size (5–12
minutes) with a preselected pressure of 30 mmHg in all chambers that cannot be changed.
• Sequence 1 is carried out six times.
• Sequence 2 and Sequence 3 are carried out only once.
Sequential inflation cycle (see page 5)
Isolation inflation cycle (see page 7)
Wave inflation cycle
• The Wave inflation cycle starts at the base of the limb, over the foot.
• As one chamber inflates, the previous chamber starts deflating, so at any one time a small
area is being compressed.
• For example: When chamber 2 is full, then chamber 1 starts to deflate, while chamber 3
starts to inflate, so for a moment, there are 2 chambers reaching the target pressure at the
same time. (See Figure 4)