Owner Manual

LIMITED WARRANTY
All products are warranted to the original consumer for normal home use for one year
from the date of sale against defects in material or workmanship. This warranty does not
cover damage which occurs while in the consumer's possession, which is not attributable
to material or workmanship defects. This warranty covers only repair or replacement to
the products. We specifically does not warrant the suitability of its products for any
particular use in any particular environment. We specifically disclaims any liability for
damages caused by use of a product in an environment unsuited for such use.
We does not warrant the suitability of these products for use with vinyl, linoleum or any
other similar floor covering. During one year period & covered defects will be remedied
by us without charge by repair, if in the opinion of repair will fully remedy the defect & is
commercially practicable, or the product will be replaced. For any such repair or
replacement, the consumer shall return the product to the place from which it was
purchased. We shall neither bear responsibility for the cost of such return not for any
other costs or damages, which the consumer may incidentally incur as a result of such
defect of the breach of any implied warranty.
Some states do not allow the exclusion or limitation of incidental damages so that the
above limitation or exclusion my not apply to you.
All implied warranties including but not limited to implied warranties of fitness &
merchantability, are limited in duration to a period ending one year from the date
of sale. Some states do not allow limitation on how long implied warranty lists,
so the above limitation may not apply to you. This warranty gives you specific legal rights
and you may also have other rights which vary from state to state.
ASSEMBLY INSTRUCTIONS:
TOOLS NEEDED:
PHILLIPS SCREWDRIVER
1) UNPACK CHAIR BUCKET AND PEDESTAL. TURN BUCKET UPSIDE DOWN.
2) REMOVE BOLTS & WASHERS FROM BOTTOM OF BUCKET AND PLACE THE PEDESTAL WITH THE KNOB FACING THE FRONT OF SEAT. LINE HOLES IN TILT TO HOLES IN THE SEAT &
SLOWLY INSERT BOLT WITH WASHER & HAND TIGHTEN HALF WAY. ADD REST OF BOLTS LEAVING ALL LOOSE UNTIL ALL ARE INSTALLED
3) WITH SCREW DRIVER START TIGHTENING THE BOLTS INTO THE THREADED T-NUTS. DO NOT TIGHTEN BOLTS HARD UNTIL ALL 4 ARE SNUG TO THE METAL PLATE.
THEN TIGHTEN UNTIL THEY WILL NO LONGER TIGHTEN.
4) INSERT ONE CASTER BY HAND & PUSH IT UNTIL IT SNAPS INTO PLACE. DO NOT USE HAMMER OR OTHER TOOL. BASES MAY ALREADY HAVE CASTERS IN PLACE.
CARE INSTRUCTIONS:
REMOVE STAINS AS SOON AS POSSIBLE. DO NOT USE ABRASIVE SOAPS OR STEEL WOOL.
VINYL-UPHOLSTERY CHAIRS: DAY TO DAY SOIL can be removed with a neutral soap & warm water.
Areas which come in contact with hair oil or tonic should be washed occasionally with neutral soap & warm water.
FABRIC-UPHOLSTERY CHAIRS: Wipe with a solution of mild soap & clear water. Sponge dry. Brush nap to original appearance.
METAL PARTS: Use a neutral soap & warm water. Rinse thoroughtly in clear water. Wipe clean with a clean cloth to avoid spots & streaks.
4 washers & bolts
already screwed into
seat bucket in bottom
GENERIC CHAIR ASSEMBLY FOR SWIVEL CHAIRS
SWIVEL KNOB IS PRE-SET AT 180 LBS.
BASE ASSEMBLY with CASTERS
THE RANGE GOES FROM 90 LBS. TO 300 LBS.
BACK
FRONT
TOP CHAIR BUCKET ASSEMBLY
PLACE KNOB TO FRONT
TO ADJUST TILT:
TURN SPRING KNOB TO COMPRESS OR LOOSEN
SPRING AS DESIRED FOR BEST COMFORT LEVEL.
IF A SLIGHT NOISE DEVELOPS, TURN THE KNOB
LIGHTLY EITHER WAY TO ELIMINATE IT.