Operation Guide

955-0002_v3.3, Rev-B COPYRIGHT © 2012 RED.cm, Inc.
189 189
LEDS
There are two status LED indicators located above the rockers switch on the left side of the LCD display.
The upper LED is used to signal camera readiness and camera record status.
• Red – Camera Startup / Camera Recording.
The lower LED is used to signal camera readiness and REDMOTE communication status to the camera.
• Green – Camera Ready / REDMOTE connected.
• Blinking Green – Searching / Establishing communication
ROCKER SWITCH
The function of the ROCKER SWITCH may be assigned by the operator to one of a number of
operational controls. Refer to SECONDARY MENUS > SETTINGS > SETUP > KEYS / SHORTCUTS.
USER FUNCTION KEYS
The function of each User Function Key may be assigned by the operator to one of a number of
operational controls. Refer to SECONDARY MENUS > SETTINGS > SETUP > KEYS / SHORTCUTS.
Default settings for User Function Keys A-D are as follows:
• User Key A – Toggles Auto Focus
• User Key B – Toggles View RAW
• User Key C – Toggles Focus Check (1:1 Magnify)
• User Key D – Toggles Sensor RAW Exposure Check
MENU BUTTON
Below and to the left of the User Keys is the MENU button, press to switch between primary level and
secondary level Camera menus. When in Camera menus or REDMOTE menus, press once to exit
menus.
SOFT MENU BUTTONS 1-3
Below the LCD are three Soft Menu Buttons, whose specific functions are indicated by the LCD screen.
For complete information refer to OPERATION > REDMOTE MENUS > SOFT MENU BUTTONS 1-3.
NAVIGATION GROUP
The Navigation Group allows navigation of the camera menus and adjustment of selected parameters.