Operation Guide

206 206 206 206

UPGRADING REDMOTE FIRMWARE

The REDMOTE update utility allows you to upgrade the firmware on your REDMOTE.

NOTE: After firmware has been upgraded, the REDMOTE must be paired to the camera again.

SETUP

CONFIGURING REDMOTE CONNECTION WITH COMPUTER (MAC)

The first step in upgrading REDMOTE firmware is to establish communication between the MAC and the

REDMOTE.

1. Connect a USB to mini-USB cable between the computer and the USB connector on the

REDMOTE.

2. Go to System Preferences and choose Network. This may open automatically when the REDMOTE

is connected.

3. Look for a device called RNDIS/ ...Gadget.

4. Change Configure IPv4 setting to “Manually” (as shown).

5. In the IP Address field, enter 192.168.0.1 (as shown).

6. In the Subnet Mask field, enter 255.255.255.0 (as shown).

7. The Status should change to “Connected” after changes.