Operation Guide

207 207

NOTE: After entering the IP address as shown above you may not connect during the upgrade

procedure. When you go back and check the IP address you see that it is 0.0.0.0 HOWEVER the

status of the device is shown as “Connected”.

If this is the case, you may need to enter the IP address a second or possibly a third time to make

it stick.

8. Click “Apply’ at the bottom of the Network window.

9. Proceed to UPGRADING REDMOTE FIRMWARE.

UPDATING REDMOTE FIRMWARE

The following information will guide you through proper updating of your REDMOTE firmware.

MAC

1. Download the camera upgrade EPIC_vX.X.XX zip file located at http://www.red.com/support.

2. The file will unzip automatically when downloaded. The REDMOTE Upgrade is located in this

download.

3. Navigate to the downloads folder and open the newly created EPIC_vX.X.XX folder; or open it

directly from the downloads window.

4. Open the REDmoteUpgrade_vXXX folder.

5. Open the MAC folder.

6. Double-click the REDmoteUpgradeApp. A Terminal window will open and the REDMOTE Software

Wizard will open.