Operation Guide

COPYRIGHT © 2012 RED.com, Inc. 955-0002_v3.3, Rev- B
220 220 220 220
SLAVE CAMERA
Perform the following steps on the Slave camera:
1. Go to SECONDARY MENUS > SETTINGS > SETUP > COMMUNICATION > NAME and give the
camera a unique NAME (CAM B, RIGHT, etc…).
2. Under TARGET select NONE.
3. Give the Slave camera a unique IP address different from the Master.
CLIP NAMING CONVENTIONS
REEL NO. / SLATE (CAMERA ID) / CAMERA POSITION
Before shooting in Master / Slave or Master / Master configuration for a Stereo / 3D production, make
sure the Camera Slate (i.e. Reel No. and Cam ID) are set to the same value for both Master and Slave
cameras. Then change the Cam Pos value from the system default of CENTER, to either LEFT or RIGHT
to identify the "left eye" and "right eye" camera in the stereo pair.
The Reel No, Cam ID and Cam Pos can be set when formatting the media or after formatting by using
the SET option. Refer to SECONDARY MENUS > MEDIA.