Operation Guide

221 221

For example, if Master is set to LEFT and Slave is set to RIGHT and both Cam IDs are set to S, the first

clip recorded by this stereo camera configuration will be:

- Master: S001_L001_0503B6.R3D

- Slave: S001_R001_0503R7.R3D

Where 0503 represents 05 March, B6 and R7 are examples of camera generated wildcard characters.

Note: If both Master and Slave cameras are accidentally left in default settings of CENTER and

CAM A ID, the clips recorded on each camera will have the same file structure, with the exception

of the camera generated wildcard characters which protect against exact file name duplication:

- Master: A001_C001_0503B6.R3D

- Slave: A001_C001_0503R7.R3D

CONNECTING CAMERAS

1. While still powered up, interconnect the cameras using a Master/Slave GIG-E Cable P/N 790-0163.

Plug the cable into the GIG-E connector on the rear of each camera body..

2. Power down both cameras, then power back up. If properly connected, LAN will illuminate Green on

the UI.

3. Connect a SYNC cable P/N 790-0154 to each camera and connect as to your 3

party device.

• Yellow BNC connector is for SMPTE unbalanced Timecode input.