Operation Guide

222 222 222 222

• Green BNC connector is for Tri-Level Sync (Genlock) input.

• White BNC connector is a dual-purpose (Shutter SYNC input or GPI) input.

4. Go to SETTINGS > SETUP > GPIO/SYNC > SYNC MODE and select GENLOCK.

5. Verify the camera’s project frame rate matches the Genlock and Timecode generator(s) framerate(s).

6. When properly connected and synchronized, TC, GEN and SYNC will illuminate Green on the UI.

OPERATION

CHANGING SETTINGS

When changes are made to the Master camera settings, the Slave camera setting will also change, but

not in real-time. For example, when you change the Frame Rate on the Master camera, you will not see

the change on the Slave camera until you set the Master camera at the new Frame Rate.

Also when making changes to the Secondary menu settings, the Slave camera will not display those

changes unless it affects items displayed on the main screen (example: when HDRx is enabled on the

Master camera, HDR will change to HDRx on the Slave camera).

RECORDING

When the power/record button is pressed on the Master camera to start/stop recording, the Slave

camera will also start/stop recording.

POWER DOWN

When the Master camera is powered down using the Secondary Menu > Power, the Slave camera will

also power down.