Operation Guide

49 49

The GUI is broken down into the following three main sections: the Upper Status Row, the Live Action

Area, and the Lower Status Row. On VIEWFINDER output(s), all three sections are visible, on PREVIEW

outputs only the Live Action Area and associated graphic overlays are visible. On PROGRAM outputs,

none of the graphic overlays are visible, i.e. a PROGRAM output is defined to be a CLEAN FEED output.

UPPER STATUS ROW

Provides immediate feedback on the most critical image composition parameter settings, including (from

Left to Right):

• Playback Access (Touchscreen)

• Current frame capture rate

• ISO Rating

• Shutter Speed (or Shutter Angle)

• White Balance

• Record Resolution

• Record Quality

• Secondary Menus Access (Touchscreen)

Whichever parameter is underlined with a red bar may be immediately adjusted by pressing ENTER in the

Navigation Group of the Side Handle or REDMOTE, then using the Scroll Wheel to change the value of

that parameter. To confirm the parameter change press ENTER a second time.

NOTE: Shutter angle is displayed in Relative mode by default, as indicated by Yellow text.

If the red bar is not on the parameter you wish to change, first use the Scroll Wheel to position the red bar

under that parameter, then press ENTER, adjust with the Scroll Wheel and press ENTER a second time to

confirm the value change.

In the above GUI example, the Scroll Wheel has been used to move the red cursor to the Shutter Speed

parameter; and the ENTER key has been pressed. This reveals the Parameter Adjust Widow. Adjust the

value using the Scroll Wheel and then press ENTER to confirm the value change, then close the sub-

menu.