User guide

DataDirect Networks SFA™ OS 2.2.1.3 Release Notes Revision A1 | 7
• SFA12K Series: 2.31.5050
• SFA10K Series 2.9.1200
How to identify new vs. old firmware
The command SHOW ICL_IOC will report firmware version 2.31.5050 on updated systems.
New version:
SFA12K[0]$ show icl_ioc
**********************
* ICL IOC(s) *
**********************
|ICL|
Idx|Ctlr|RP|IOC| Type |Vendor|Product| Slot | Model Name | HW Version | FW Version…
----------------------------------------------------------------------------------…
0 1 0 00 IB HCA 15b3 1003 2 MT4099 0x00000000 2.30.5050…
Old version:
|ICL|
Idx|Ctlr|RP|IOC| Type |Vendor|Product| Slot | Model Name | HW Version | FW Version…
----------------------------------------------------------------------------------…
0 1 0 00 IB HCA 15b3 1003 2 MT4099 0x00000000 2.30.3000…
4. Finally, the InfiniBand cards have their firmware updated if they don’t have the latest
version. It takes less than a minute per card (so four cards would take less than four
minutes) and one reboot.
2.5 Post-Firmware-Upgrade Procedure
SFA12K Series and SFA10K Series Products
After upgrading the firmware, perform these steps to initialize the battery life remaining
feature:
1. Issue the command, SHOW UPS * ALL_ATTRIBUTES.
2. If you see a date in “Battery Mfg. Date”, do nothing more, this procedure is
complete.
3. If you see the message shown in Figure 3, then issue the command, SET UPS <id>
BATTERY_MANUFACTURE_DATE=MM-DD-YYYY, where “id” is the ID of the UPS that
needs to be given a date, and MM-DD-YYYY is the date when the UPS battery was
put into service (typically the install date of the subsystem).
Figure 3
Battery Mfg. Date: NOT AVAILABLE
Battery Life Remaining: NOT AVAILABLE
4. Issue the command, SHOW UPS * ALL_ATTRIBUTES. You should see the message
shown in Figure 4.