Installation guide

Chapter 4. LVM Administration with CLI Commands

filter = [ "a/.*/" ]

The following filter removes the cdrom device in order to avoid delays if the drive contains no media:

filter = [ "r|/dev/cdrom|" ]

The following filter adds all loop and removes all other block devices:

filter = [ "a/loop.*/", "r/.*/" ]

The following filter adds all loop and IDE and removes all other block devices:

filter =[ "a|loop.*|", "a|/dev/hd.*|", "r|.*|" ]

The following filter adds just partition 8 on the first IDE drive and removes all other block devices:

filter = [ "a|^/dev/hda8$|", "r/.*/" ]

For more information on the lvm.conf file, see Appendix B, The LVM Configuration Files and the

lvm.conf(5) man page.

4.6. Online Data Relocation

You can move data while the system is in use with the pvmove command.

The pvmove command breaks up the data to be moved into sections and creates a temporary mirror

to move each section. For more information on the operation of the pvmove command, see the

pvmove(8) man page.

The following command moves all allocated space off the physical volume /dev/sdc1 to other free

physical volumes in the volume group:

# pvmove /dev/sdc1

The following command moves just the extents of the logical volume MyLV.

# pvmove -n MyLV /dev/sdc1

Since the pvmove command can take a long time to execute, you may want to run the command in

the background to avoid display of progress updates in the foreground. The following command moves

all extents allocated to the physical volume /dev/sdc1 over to /dev/sdf1 in the background.

# pvmove -b /dev/sdc1 /dev/sdf1

The following command reports the progress of the move as a percentage at five second intervals.