User's Manual

ManualsBrandsRed-M ManualsElectronicsBluetooth Access Server

Safety and Regulatory Information

This section lists required safety, conformity and regulatory

information for certain jurisdictions.

For the latest and updated information, please refer to the ratings

plate on the Red-M 3000AS access server.

European Economic Area

United States

Canada

European Economic Area

See the (currently unsigned) Certificate of Conformity. (Requires

Adobe Acrobat Reader.)

We, Red-M, declare under our sole responsibility that the 3000AS

is in conformity with the provisions of Council Directive

1999/5/EC on radio equipment and telecommunications terminal

equipment and the mutual recognition of their conformity.

This equipment is intended to be used in all Member States of the

European Economic Area (EEA).

It is intended to be directly connected to BRI ISDN public

telecommunications network interfaces in all EEA Member States

with the exception of Sweden and Norway. In these countries it

may only be indirectly connected behind a device providing

supplementary insulation for a primary circuit between the ISDN

port of this product and the ISDN network interface as detailed in

the relevant special national conditions of EN60950: 1992 clause

6.2.1.2.

It is designed to connect to "Bluetooth" compatible radio

interfaces using the 2.4 GHz frequency band in all EEA Member

States with the exception of France where the use of the

following frequencies is restricted:

2.4000 - 2.4460 GHz - Use Excluded - Military Band

2.4540 - 2.4835 GHz - Limited to indoor video

applications

[Member States of the EEA are: Austria, Belgium, Denmark,

Finland, France, Germany, Greece, Iceland, Ireland, Italy,

Luxembourg, Liechtenstein, Netherlands, Norway, Portugal,

Spain, Sweden, Switzerland, United Kingdom.]

Summary of content (5 pages)

PAGE 1
Safety and Regulatory Information This section lists required safety, conformity and regulatory information for certain jurisdictions. For the latest and updated information, please refer to the ratings plate on the Red-M 3000AS access server. European Economic Area United States Canada European Economic Area See the (currently unsigned) Certificate of Conformity. (Requires Adobe Acrobat Reader.
PAGE 2
top United States This equipment complies with part 15 of the FCC rules. Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. This equipment complies with Part 68 of the FCC rules. On the rear of this equipment is a label that contains, among other information, the FCC registration number for this equipment. If requested, the following information must be provided to the telephone company.
PAGE 3
telephone company may request that you disconnect the equipment until the problem is resolved. Connection to party line service is subject to state tariffs. (Contact the state public utility commission, public service commission or corporation commission for information.) It is strongly suggested that an AC surge arrestor is installed in the AC outlet to which this equipment is connected. CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
PAGE 4
Operation is subject to the following two conditions: [1] this device may not cause harmful interference, and [2] this device must accept any interference, including interference that may cause undesired operation of the device. This device has been designed to operate with an antenna having a maximum gain of 0dB. An antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
PAGE 5