Product Manual

9
2 INSTALLATION
2.7 Cable sizing
Below is a table outlining the required cable size for a given cable install length.
Always choose a wire diameter equal to or greater than what is specifi ed below.
Part Number Cable Install Length
(m)
Recommended Wire
Size (mm²)
Closest (BAE, B&S,
AWG)
BCDC2420(LV) 1 - 5 13.56 6
5 - 9 20.28 4
2.8 Wiring
The heavy gauge wires on the BCDC2420(-LV) unit carry peak currents of up to
40 Amps, and it is important to make a good, low resistance, electrical connection
that will not degrade over time. Failure to make a good, reliable contact may
result in breakdown of the wire insulation and cause a short circuit, or worst case
a fi re. We recommend that this activity be undertaken by an appropriately trained
person.
REDARC recommends using a soldered butt splice crimp connection that is
covered with heatshrink. See Figure 2.8. REDARC does not recommend using
standard red/ blue/yellow blade connections as they are not rated for either the
current required or gauge of wire supplied on the unit.
Crimping provides good mechanical connection, soldering provides a long lasting
electrical connection and forming of the heatshrink will prevent any shorting/
contact with your vehicle chassis.
Figure 2.8 - Ensuring a good wiring connection
Crimp here.
Crimp both wires to the butt splice using
indent type crimpers.
Solder Both Ends Here.
Solder the wires to the butt splice.
Ensure that a good connection is
made. Keep heatshrink away until after
soldering is complete and has cooled.