Specifications

44
6. Carburetor
6-4 Limiter Cap Removal/ Installation
Tool
The limiter cap tool (carburetor maintenance tool:
848-8W9-0080) is used for limiter cap
installation/removal.
Removal
Insert the limiter cap tool extraction tool's threading
(M2 counterclockwise threading) into the idling
limiter's hole and screw it counterclockwise while
giving pressure.
When it is firmly threaded, pull the limiter cap.
If it is difficult to screw in the limiter cap tool,
firmly press the tool while screwing. When
threads are completely meshed, pull it out in
one stroke. If cap is damaged and stays in
the hole, use a pick type tool to remove it.
Installation
Insert a new limiter cap in the low speed mixture
needle hole. Press the cap deeply into low speed
mixture needle hole to prevent tampering.
Be sure to install only a new limiter cap.
The limiter cap is a very small part. Pay
attention not to lose it.
6-5 Idling Speed Adjustment
Slow and Middle Speeds All Models
Adjust the fuel supply under idling conditions by turning the idling limiter.
1. Remove the limiter cap.
(Refer to "6-4 Limiter Cap Removal/ Installation".)
After completion of the adjustment, be sure
to install the limiter cap.
2. Turn the screw with a commercially available screw
driver (tip width: 2.5mm).
Clockwise (CW):
Fuel mixture becomes lean. (Speed increases.)
Counterclockwise (CCW):
Fuel mixture becomes rich. (Speed decreases.)
CAUTION
CAUTION
Limiter cap insertion side
Limiter cap
(new part)
CAUTION
Screw Driver
Increases Decreases
Limiter cap insertion side
Limiter cap tool extraction side
Screw unit
(M2 counterclockwise threading)
Limiter Cap Tool
Limiter Cap
Limiter cap tool extraction side
Press it while turning it
counterclockwise.
Pull it out.
Limiter cap is
removed.