Operation Manual

10
Mode
Fast
Cooking time, min
Default time, min
Time
Delay
Re-
heat
Fast
Nor-
mal
Slow
STEW
Meat 30 40 50 40 + +
Vegetables 15 20 25 20 + +
Poultry 20 35 45 35 + +
Fish 15 20 30 20 + +
STEAM
Meat 15 20 25 20 + +
Vegetables 6 10 15 10 + +
Poultry 8 10 15 10 + +
Fish 10 15 20 15 + +
MULTI-CHEF
Set manually
from 20 to 99 minutes
– + +
V I. CARE OF THE APPLIANCE
Before cleaning the inside surface of the multicooker, make sure it is unplugged
from the mains and has cooled down completely.
Before using the appliance for the rst time, as well as to get rid of food odour
after use, place a lemon inside for 15 minutes in BOIL mode.
Do not leave the multicooker closed with water in the bowl for more than
24hours. Food can be stored in the bowl in the fridge and reheated using the
reheat function.
If the appliance is not used for a long period of time, make sure it is unplugged
from the mains. The inside, bowl, inner lid, and steam valve should be kept clean
and dry.
Before cleaning the appliance, make sure it is unplugged from the mains and
has completely cooled down. Use a soft cloth and a gentle washing-up liquid.
Be careful not to damage the rubber parts: this can affect the work of the ap-
pliance.
DO NOT use rough cloths or abrasives to clean the appliance. Do not use any
chemicals or other substances which are not recommended for items that
come into contact with foodstuffs.
Clean the surface as required. Clean the bowl after each use. The inner alu
-
minium lid and removable steam valve should be cleaned after each use.
Remove any condensation that forms in the multicooker after each use. Clean
the inside surface as required.
Clean the surface of the appliance with a soft kitchen cloth or sponge. Gentle
cleaning substances can be used. Wipe the appliance dry to avoid leaving any
watermarks or stains on the surface.
The bowl can be cleaned with a soft sponge and washing-up liquid, or in a
dishwasher. For stubborn stains, pour warm water into the bowl and leave it to
soak before cleaning. Always wipe the outer surface of the bowl dry before
replacing it inside the multicooker.
Clean the inner surface of the lid after each use:
1. Open the lid. Inside, in the middle, is the xing bolt. Supporting the lid,
unscrew the bolt (counterclockwise) and carefully separate the lid from
the lever of the hinge mechanism.
2. Clean the inner surface of the lid and wipe it dry.
3. Replace the lid: align the hole in the centre of the lid with the screw on
the lever of the hinge mechanism (the lid-locking lever should be on the
top) and, supporting the lid, screw on the xing bolt (clockwise) as far as
it will go.
For more rigorous cleaning, remove the sealing ring from the inner surface of
the lid and dismantle the steam-release valve.
1. Remove the valve switch on the outside of the lid by pulling it upwards.
2. Unscrew the protective cover on the inside of the lid.
3. Rinse both parts of the valve in warm water.
4. Screw the protective cover back in place and push the valve switch
lightly back into its socket to secure it.
5. The pressure-regulating shutdown valve is inside the lid. Carefully remove
any dirt from the valve and sealing ring with a damp sponge or kitchen
cloth.
The steam-release valve and shutdown valve should be cleaned after every
use.
Clean the sealing ring on the inside of the lid as required: carefully remove the
ring, rinse it in warm water and replace accurately.
The condensation tray at the back of the appliance should be cleaned regu
-
larly. Pull the tray down to remove it. Pour away the water, rinse the tray and
replace.
If the instructions are followed carefully, there is very little chance of water,
bits of food or waste getting inside the appliance. If there should be a signicant
build-up, however, this can damage the appliance. In this case, clean the inside
surface.
The side walls, bottom and cover of the central temperature sensor (on the
bottom, in the centre) can be cleaned with a dampened sponge or cloth. If you
use a detergent, it must be wiped off completely to avoid smells when cooking.
If there is anything caught in the recess around the central temperature sensor,
remove it with tweezers without pressing on the cover of the sensor.
VII. BEFORE CONTACTING THE
SERVICE CENTRE
Error message
on display
Possible problems Solution
 Pressure sensor error
Unplug the appliance and let it cool
down. Close the lid tightly. If the prob-
lem has not been solved, contact an
authorised service centre

System error, the control
boards or heating element
may have malfunctioned
Contact an authorised service centre
 Overheating
Unplug the appliance and let it cool
down
Problem Possible cause Solution
Will not switch on
No power in the electrical supply
Check the voltage in your electri-
cal supply
The lid does not
close hermetically.
Steam escapes
through the lid
during cooking
The sealing ring in the lid is miss-
ing or crooked
Replace it accurately
The sealing ring in the lid is dirty Clean the ring
The sealing ring is deformed Replace it
Problem Possible cause Solution
The food takes too
long to cook
Unstable electrical supply
Check the voltage in your electri-
cal supply
Something trapped between the
bowl and the heating element
Remove the item
The bowl is crooked Replace it correctly
The heating element is dirty
Unplug the appliance and let it
cool down. Clean the heating ele-
ment
VIII. PRODUCT WARRANTY
We warrant this product to be free from defects for a period of 2 years from the
date of purchase. If the appliance fails to operate properly within the warranty
period and is found to be defective in material or workmanship, we will repair
or replace it. This warranty comes into force only in case the purchase date can
be proved with an original warranty service coupon containing a serial article
number and accurate impress of the company of the seller. This limited war
-
ranty does not cover damage caused by the failure to use this product for its
normal purpose or in accordance with the instructions on the proper use and
maintenance of the product, or any kind of repair works. Do not try to disas
-
semble the device and keep all package contents. This warranty does not
cover normal wear of the device and its parts (lters, bulbs, non-stick coating,
sealing rings, etc.).
Service life and the applicable product warranty period start on the date of
purchase or the date of manufacture (if the purchase date cannot be established).
You can determine manufacture date by the serial number on the identication
label on the housing of the device. The serial number consists of 13 digits. The
6th and 7th digits of the serial number refer to the month, whereas the 8th
digit refers to the year of manufacture.
Service life of the product, established by the manufacturer is 5 years from the
date of purchase, provided that the appliance is used and maintained in ac
-
cordance with the user manual and applicable technical standards.
Environmentally friendly disposal (WEEE)
The packaging, user manual and the device itself shall be taken to
the applicable collection point for the recycling of electrical and
electronic equipment. Do not throw away the electronic waste to
help protect the environment.
Old appliances must not be disposed with other household waste
but must be collected separately. Municipal disposal of recyclable
wastes is free of charge. The owners of old appliances are required to bring it
to a waste facility centre. With this little extra effort, you can help to ensure
that valuable raw materials are recycled and pollutants are treated as appropri-
ate.
This appliance is labelled in accordance with European Directive 2012/19/EU
— concerning used electrical and electronic appliances (waste electrical and
electronic equipment WEEE).
The guideline determines the framework for the return and recycling of used
appliances as applicable throughout the EU.