Instructions

28
9. Setting up the Transmitter
 Inthefurthercourseoftheseinstructions,guresinthetextalwaysrefertotheadjacentgureorthegures
withinthesection.Referencestootherguresareindicatedwiththecorrespondinggurenumber.
 Theguresoftheremotecontrolandmodelintheseinstructionsserveonlyillustrativepurposes.Stickers,
design and colouration may deviate from the pictures in the instructions in serially delivered products.
a) Inserting the Batteries
The power supply of the transmitter requires 6 mignon batteries (e.g. Conrad Item No. 652506, please order 6x).
Proceed as follows to insert the batteries:
Loosen the retention screw (1) of the battery compartment
lid (2) on the back of the transmitter and lift off the battery
compartment lid.
Insert the batteries observing the correct polarity accord-
ing to the note in the battery compartment (3).
Put on the battery compartment lid again and tighten the
retention screw (1).
Figure 2