Instructions

46
Remove the bracket (A) of the battery holder by pulling out
the two safety clips (B) and then pulling out the bracket
upwards.
Now insert the drive battery so that the connection cable of
the rechargeable battery points backwards.
Otherwise, the connection cable could impair the steering
mechanism in its function.
Put on the bracket of the battery holder again and attach it
with the safety clips removed in the beginning.
f) Connecting the Drive battery to the Speed Controller
First switch off the speed controller. The on/off switch (A)
isatthetopofthechassis,rightnexttothemotor,see
gureontheright.
Nexttotheon/offswitch(A),thereisthesetupbutton(B)
that is used for programming (see chapter 10).
To switch it off (switch position „OFF“), move the slider to
the left (away from the motor).
Then switch on the transmitter if you haven‘t done so yet
(see chapter 9. c) and d).
To prevent sudden start-up of the wheels and therefore uncontrolled starting of the model (e.g. if the trim-
mingforthedriveismaladjusted),placethemodelvehicleonasuitablesupport(orstartingbox),sothat
the wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable =
minus/-). Do not apply any force when connecting the battery plug to the connection of the speed controller.
Make sure that the cables do not get into the drive of the vehicle or the steering mechanics. Use cable binders for
fastening if required.