Instructions

47
g) Switching on
Switchonthespeedcontrollerbymovingtheslider(seegureinchapter9.f)totherighttowardsthemotor(switch
position„ON“).Thenwaitforafewseconds(leavethethrottle/brakeleveronthetransmitterintheneutralposition;
do not move it).
If the vehicle drive starts although the throttle/brake on the transmitter is in the neutral position, then adjust
the trim on the transmitter until the motor stops.
 Ifthetrimmingpathisinsufcient,theneutralpositionmustbeprogrammed,seechapter10.a).
Now check the drive and steering functions of the vehicle.
For programming the speed controller, please observe chapter 10. b).
Important!
If a LiPo battery is used as a drive battery, check the basic settings of the speed controller for whether
undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the
LiPo battery will suffer deep discharge and be destroyed.
If a NiMH driving battery is used, switch off undervoltage recognition or set it to a lower value than for LiPo
batteries, see chapter 10. b).
The LED at the speed controller goes out in the neutral position or is lit in red when driving forward and backwards.
The LED lights up green when driving forwards and at full throttle.
h) Attaching and Fastening the Car Body
Fold the car body closed and guide the aerial tube through the corresponding opening from the bottom of the car body.
Fasten the car body at the chassis with the two safety clips (see chapter 9. a).
i) Controlling the Vehicle
Put the ready-to-run vehicle on the ground. Do not reach into the drive, and to not hold the vehicle at its rims.
Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive too fast at
the beginning until you get used to the car‘s reactions. Do not make any quick and jerky movements with the operating
elements of the remote control.
Neverpointthetransmitteraerialdirectlyontothevehicle.Itwillstronglydecreasetherange.Themaximumrangewill
be achieved when the aerial of the transmitter and vehicle are both vertical and in parallel to each other.
If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly.
Whenswitchingbetweenforwardandreversegears,thethrottle/brakelevermustbeputintheneutralpositionbriey
(neutral position = let go of lever, do not move it). If the throttle/brake lever is moved from forward to reverse directly,
the brake function of the drive is activated (vehicle will NOT reverse).
Waitforatleast5-10minutesuntilmotorandspeedcontrollerhavecooleddownsufcientlybeforethenextrun.Only
then start a new drive with a full drive battery.