Instructions

• Function #4, green LED ashes 4x short: Start mode when driving off

Depending on this setting, the take-off/start speed is more or less powerful. The higher the set value, the more

currentwillthemotorpullfromtheconnectedbattery;itmustaccordinglybeofhigherquality.

A higher setting also should only be used on loose underground, since otherwise there will be an overload of the

drive (gear, differentials).

• Function #5, green LED, ashes 5x short: Maximum braking strength

The speed controller unit allows proportional braking strength depending on the setting of the transmitter lever. The

maximumbrakingpoweratfullleverextensioncanbeadjustedto25%,50%,75%and100%.

A high setting (e.g. 100%) decreases braking distance but has a negative effect on the lifetime of the drive

(specicallyforthedrivepinionandthemaingear).

c) Resetting the Speed Controller

This function will reset all settings that were adjusted when setting up the speed controller unit to the original factory

settings (see grey marker in the table in chapter 10. b).

Proceed as follows:

• Switch on the transmitter. Leave the throttle/brake lever in its neutral position and do not move it.

• Switch on the speed controller (move the slider towards the setup button). The vehicle should now be ready for

operation;noLEDislitonthespeedcontroller.

• PressandholdthesetupbuttonuntiltheredandgreenLEDsashslowlyatthesametime.

• Turnoffthespeedcontroller(switchto„OFF“;seegureinchapter10.a)orb).Allsettingsarethenresettothe

factory setting, see table in chapter 10. b).

For reprogramming of the speed controller, observe the above chapters 10. a) and b).

Important!

If a LiPo battery is used as a drive battery, check the basic settings of the speed controller for whether

undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the

LiPo battery will suffer deep discharge and be destroyed.

If a NiMH driving battery is used, switch off undervoltage recognition or set it to a lower value than for LiPo

batteries, see chapter 10. b), function #3.