Instructions

62
The vehicle doesn‘t drive in a straight line correctly
• Set straight driving at the transmitter using the respective trimming control for the steering function.
• Check the steering rods, the servo arm, the servo saver and its screw connections.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
Steering works opposite to the way the turning wheel is turned at the transmitter
• Activate the steering reverse setting at the transmitter.
Driving works opposite to the movement of the throttle/brake lever at the transmitter
• Usually, the vehicle should drive forwards if you pull the throttle/brake lever at the transmitter towards the handle.
If this is not the case, activate the reverse setting for the driving function at the transmitter.
• If the motor has been disconnected from the speed controller, swap two of the three motor cables.
The steering is not functioning or is functioning incorrectly, steering deection at the vehicle insufcient
• If the transmitter offers dual rate settings, check these settings (observe transmitter’s operating instructions). If the
dual rate setting is too low, the steering servo will no longer react.
• Checkthesteeringmechanicsforlooseparts;e.g.checkiftheservoarmisproperlyattachedtotheservo.
The white LEDs at the top of the car body do not light up
• Switch on the LEDs via the associated on/off switch.
• Check that the connection plug of the LEDs is connected to the receiver and whether the polarity of the plug is cor-
rect (all black cables from the steering servo, speed controller and LED lamps point to one side).