Instructions

f) Inserting the vehicle battery

Important!

This vehicle is only suitable for use with a 6-cell NiMH battery (nominal voltage 7.2 V) or a 2-cell LiPo bat-

tery (nominal voltage 7.4 V).

 Usingadrivebatterywithmorecellsmaymakethespeedcontrolleroverheatandcauseare.Inaddition,

the powertrain may be damaged due to overload (e.g. differential), which will void the warranty/guarantee!

Check whether the battery has a suitable connector system for the speed controller and that the polarity is

correct (red cable = positive/+, black cable = negative/-).

Loosen the two straps (A) on the battery holder.

Insert the vehicle battery into the battery holder (B).

If the battery connection cable is very short, the battery

must be inserted into the battery holder so that the con-

nection cable points towards the rear of the speed con-

troller

Pull the straps (A) tight so that the vehicle battery is se-

curely in place, and then secure the straps.

g) Connecting the vehicle battery to the speed controller

 Placethevehicleonasuitablesupport(orastartbox)sothatthewheelscanmovefreely.Thisensures

that you will not lose control of the vehicle if the wheels move suddenly (e.g. if the throttle trim is not set

correctly).

Do not reach into the motor or hold the wheels in place.

Switch off the speed controller (move the switch to the

"OFF" position). The on/off switch (A) is located on the

rear of the vehicle between the two chassis holders.

Switch on the remote control (see sections 9. d) and 9. e).

Connect the vehicle battery to the speed controller. Ensure

that the battery is inserted in the correct polarity (red cable

= positive/+, black cable = negative/-). Do not use force

when connecting the battery plug to the speed controller.

Important!

This vehicle is only suitable for use with a 6-cell

NiMH battery (nominal voltage 7.2 V) or a 2-cell

LiPo battery (nominal voltage 7.4 V).

Make sure that the cable cannot get into the vehicle's drive or into the steering mechanism. If necessary, use cable

ties to fasten the cables.