Instructions
41
To enable normal mode, proceed as follows:
• Switchontheremotecontrol.Switchonthespeedcontrollerandwaituntilyouhearthenoticationtonesindicating
the undervoltage detection is enabled.
• Hold down the button on the speed controller.
• Ifthemotoremitsashortbeep("•"),thisindicatesthatnormalmodeisenabled.Releasethebuttonimmediately.
• TheredLEDonthespeedcontrollerisashing(normalmode).
To enable crawler mode, proceed as follows:
• Switchontheremotecontrol.Switchonthespeedcontrollerandwaituntilyouhearthenoticationtonesindicating
the undervoltage detection is enabled.
• Hold down the button on the speed controller.
• Ifthemotoremitstwoshortbeeps("••"),thisindicatesthatcrawlermodeisenabled.Releasethebuttonimmedi-
ately.
• The red LED on the speed controller is constant (crawler mode, optimized for the vehicle).
11. Adjusting the shock absorbers
Rear axle Front axle
The knurled wheel (A) can be used to adjust the spring preload.
The shock absorbers can be mounted on the upper end (B) in different positions to change the behaviour of the shock
absorbersduringextensionandcompression.
Alwaysensurethattheshockabsorbersoneachaxlearelevel(i.e.ontheleftandrightwheelofthefrontorrearaxle),
otherwise the vehicle may not respond correctly.