Installation Guide

Installation Instructions
Jeep Liberty
Part Numbers:
51054
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm, 19mm
Drill Bits: None
2
Existing weldnuts in vehicle
frame (3) places each side
1. If vehicle is equipped with a fuel tank skid shield, remove six (6) M12 fasteners holding skid shield to vehicle frame rails and discard
bolts.
2. Raise hitch into position and install fasteners as shown above. Fuel tank skid shield will be sandwiched between hitch and vehicle
frame rails.
Rev. C10-16-09N51054Sheet 1 of 1
z 2001, 2002, 2003, 2004, 2006, 2009 Cequent Performance Products
Conical Washer 1/2Qty. (6)
2
Hex Bolt M12 X 1.75 X 40Qty. (6)
1
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: F51054
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227 Kg)5000 (2270 Kg)
Weight Carrying
Ball Mount
750 (341 Kg)7500 (3405 Kg)
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV1, SUV2
Form: F205 Rev A 5-6-05
Fascia
Fuel tank skid shield
Frame rail
1
Note: Fasteners typical both sides