User Manual

ManualsBrandsReflecmedia ManualsContinuous Lighting8 x 8' Deskshoot Lite with Medium Dual LiteRing and Controller Kit

 

     

    



Summary of content (15 pages)

PAGE 1
��
PAGE 2
��
PAGE 3
��
PAGE 4
��
PAGE 5
��
PAGE 6
��
PAGE 7
��
PAGE 8
��
PAGE 9
�� Quick Start 1. Position your talent a minimum of 10ft/3metres from you camera. The talent should be a distance of 3 to 4ft from the Chromatte. 2. Light your talent and not the Chromatte. Large amounts of spill light on to the Chromatte will create hard shadows and can cause the blue/green from the LiteRing to be bleached out. For further lighting assistance please refer to 'lighting set-up' on page 11. 3. White balance the camera before turning the LiteRing on.
PAGE 10
�� Two Person Set-up Soft light to Fill �� Each Back light contains a half scrim. �� Before you start to light ensure the camera is set up as follows Iris manual Gain - 0db ATW - off White balance preset or manual white balance Setting the cameras white balance 1. Ensure the LiteRings are switched off 2. Make sure there are no coloured gels on the lights at this time 3.
PAGE 11
�� The lighting levels depend very much on the sensitivity of video camera you are using, however as a general rule you should be trying to light to between 500 and 1000 lux. This is typical of a 650w fresnel lamp flooded at approx 5m (16ft) from the subject. The use of a steep back light behind the subject illuminating the head and shoulders is also recommended.
PAGE 12
�� Signals, Formats and Resolutions. Always try and capture your footage using the best available video signal/format. For example, Y/C (S-Video) is better than Firewire or composite as these add compression to the image and make it harder to separate the colour channels. If you can use a component or an SDI signal then your result will be further enhanced.
PAGE 13
��
PAGE 14
��
PAGE 15
��