User Manual

Setting up
The Brio will work well on most surfaces, such as a shelf or table, provided there is sufficient air around the
amplifier to prevent overheating. If using a turntable, magnetic interference can be avoided by positioning
the amplifier as far away from the cartridge as the tonearm lead will allow. It is recommended not to stack
other hi-fi equipment directly on top of the amplifier. Never place it on fabric or carpet.
Speakers
Fuse
Power
LEFT
RIGHT
1 2 3 4 5 6
Record
output
Phono
Inputs
Connectivity
All line level inputs and outputs are made via RCA (phono) connectors.
Earthing
The Brio is fully earthed, but you may need to earth your turntable via the tonearm. For Rega turntables,
earthing is achieved via the Phono lead ground therefore a separate earth is not necessary. If your tonearm
has a separate earth lead it will need to be connected to the earthing nut located on the underside of the
amplifier. You can use the nut to clamp down onto the earthing wire, but ensure that the turntable and Brio
are as far away as possible whilst ensuring the safety of both products.
English
3
This input is a phono
stage that can be used
with moving magnet
(MM) or specifically
high output moving
coil (MC) cartridges.
Line inputs enable the
connection of any
additional sources
such as CD players,
BluRay players,
streamers etc. Note
the record output is
disabled when input 5
is selected.
For connection to any
recordable device. The
output is a ‘record
signal’ as selected by
the main input selector
1-4. This output is not
affected by the volume
control.
For earthing tonearms,
located on bottom of
Brio.
Top row: Left speaker
Red and Black.
Bottom row: Right
speaker Red and Black.
1. Phono stage input 2-5. Line level input 6. Record output Earthing nut Loudspeaker output
WARNING: CASE CAN GET HOT.