Installation manual

10
Regency I2400M
INSTALLATION
Faceplate Assembly
Prior to sliding your insert into its nal position
and attaching the connector or liner pipe, the
faceplate side panel plates must be installed
as follows:
 Slide the spring nuts (supplied) over the
slots in the insert’s side convection panels
(the spring nuts may need to be squeezed
with a pair of pliers rst, to help them stay
in position).
 Screw the side faceplate panels, (item A in
the diagram) one to each side.
 Using the top panel (item B in the diagram)
as a gauge, check that the side panels are
within approximately 1/4" of the overall width.
If the difference is greater than this, use
the supplied washers to attain the required
width.
The unit may now be slid into nal position
and attached to the connection system.
 Once connection is made, the insulation strips
should be installed between the insert face-
plates and the replace face. The faceplate
top may now be installed (with insulation
strip behind) by aligning its brackets with the
top ange on the side shields and the angle
iron bar on the insert top. The faceplate trim
may be installed to the edge
of the faceplate at this time.


 




    

Now that your insert is installed, check once
more that all the clearances from the unit to
any combustible materials are correct as listed
earlier.