Installation manual

Regency P33 Sunrise

Gas Fireplace

INSTALLATION

Wherever necessary due to

external location of cap, the

AstroCap can be replaced with

the FPI Riser Vent Termina-

tion Cap.

REGENCY

DIRECT VENT FLEX SYSTEM

Horizontal Terminations Only

This venting system, in combination with the P33S-4 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock

Hersey. The location of the termination cap must conform to the requirements in the "Exterior Vent Terminal Locations" Section .

Regency

Direct Vent Flex Termination Kit (Part # 946-513) includes all the parts needed to install the P33S-4 with a maximum run of 2

feet. If installing the P33S-4 with a continuous vent length of more than 2 ft (.6m) to a maximum of 10 ft. (3.0m) use Kit # 946-515 (4 ft) or 946-

516 (10 ft) or see "Rigid Pipe Venting Systems" Section for alternate venting arrangements.

MINIMUM

FLEX KIT CENTER-LINE

MINIMUM

RIGID PIPE CENTER-LINE

AstroCap Flex Kits

1 6-7/8" dia. ﬂ exible liner (kit length)

2 4" dia. ﬂ exible liner (kit length)

3 spring spacers (3)

4 thimble (2)

5 AstroCap termination cap (1)

6 screws (12)

7 tube of Mill Pac (1)

8 plated screws (8)

9 screws #8 x 1-1/2" drill point,

stainless steel (4)

Notes:

1) Liner sections should be continuous

without any joints or seams.

2) Only Flex pipe purchased from Regency

may be used for Flex installations.

Alternate

Horizontal

Termination

Caps

INSTALLATION

Note: - Unit must be raised by 1".