Installation manual

Regency Plateau™ PTO30 Outdoor Gas Fireplace

INSTALLATION

BURNER PACKAGES

Unit Glass Crystals Only *Glass Crystals + Volcanic stones¹

PTO30 10 lbs 5lb glass + 1 box stones- recommended

PTO60 20lbs 10lb glass + 2 boxes - recommended

NOTE: * Glass Crystals are available in 1lb and 5lb bags.

¹ Glass Crystals to be installed on the burner prior to installing stones.

Basalt Volcanic Stones are measured by weight not quantity. Each bag contains 15 lbs of stones, however the exact quantity

and size vary. Sizes vary between 2" - 3"

Evenly spread the Glass Crystals and optional Basalt Volcanic Stones over the burner. Ensure the crystals (or stones) do not overlap too much as

this will effect the ﬂ ame pattern.

IMPORTANT NOTE:

Only the supplied approved Glass Crystals and Basalt Volcanic stones are to be used with these ﬁ replaces. Use of any other type of glass crystals

or stones can alter the unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.

When using Basalt Volcanic Stones DO NOT cover pilot light that lead to pilot ﬂ ame.

1. Start pouring Crystals on one end of

the burner.

2. Work Crystals to other end of the

Burner. Base and burner tube

should not be visible when crystals

are spread out.

3. Work Crystals downwards to front

edge of top edge of burner.

4. Basalt Volcanic Stones shown

spread evenly over the burner and

crystal base.

5. Ensure Crystals do not block the

front of the pilot hood and ﬂ ame to

light the burner.

NOTE: Basalt Volcanic Stones are NOT to be placed anywhere on the Pilot assembly area.

Glass Crystals to be installed on the burner prior to installing stones.

NOTE: Correct ﬁ nal glass installation of Crystals as shown in step 2 and 3.

The Burner should not be visible when the ﬂ ame is out.

GLASS CRYSTAL / BASALT VOLCANIC STONES INSTALLATION