Installation manual

Regency Plateau™ PTO30 Outdoor Gas Fireplace

INSTALLATION

GLASS SURROUND INSTALLATION

1. Remove metal fasteners from the corner brackets.

2. Assemble the 4 pieces of the glass surround/windshield and fasten

together with 4 corner top brackets and supplied nylon fasteners as

shown below.

3. Using a ﬂ at screwdriver, secure 4 top corner brackets with nylon

fasteners in each corner, bracket should be ﬂ ush with the top of glass

as shown below.

5. Secure bottom corner brackets with nylon fasteners in each corner.

6. Flip the glass back over and place on a soft surface. The glass is now

right side up. The glass should be raised up 1/2" in bracket as shown

below.

4b. Use supplied spacer tool to determine where the bottom bracket

should be placed and secured.

4a. After the 4 top brackets are installed - ﬂ ip over and place on a soft

surface, to install the 4 bottom brackets.

7. Place assembled glass surround/windshield on table top - ensure glass

is centered on the table top. Once in correct position, lift up one end,

apply double sided tape that has been cut to size, to the bottom of the

brackets. Repeat process on other end. Press down ﬁ rmly from to

secure glass surround/windshield in position. Use care not to scratch

surfaces.

1/2"

Insert nylon fastener

here.

Spacer tool

Bottom Bracket

Top Bracket

Nylon fasteners

THE GUARD IS FITTED TO THIS APPLIANCE TO REDUCE THE RISK OF FIRE OR INJURY FROM BURNS AND NO PART OF IT SHOULD BE

PERMANENTLY REMOVED.

FOR PROTECTION OF YOUNG CHILDREN OR THE INFIRM , A SECONDARY GUARD IS REQUIRED.