User`s guide

Page 9
Battery Installation
The TONO-PEN VET is supplied with four Ocu-Cel™ XL 3.0 volt lithium manganese
dioxide batteries that need to be installed in the TONO-PEN VET. It is recommended
that Reichert Ocu-Cel XL Batteries be used when the batteries need replacement.
Note: The TONO-PEN VET unit will not function properly with mercury batteries.
Installation Procedure
Locate the battery compartment (see Figure 4). Open the battery
compartment by gently inserting the stylus blade (see Figure 4) in the end
slot. After insertion, slowly push the stylus forward and pry the cover up to
remove.
Using the other end of the stylus, insert the tip into the holes on the underside
of the body mold. Insert the tip perpendicular into the battery removal holes
on the bottom of the base housing to push the batteries out (see Figure 4).
Insert two batteries as shown in Figure 4 (also diagrammed on the oor of the
battery compartment).
Replace the battery cover.
CAUTION
CHECK TO BE SURE THAT THE BATTERIES ARE INSTALLED CORRECTLY.
INCORRECT INSTALLATION COULD CAUSE SEVERE DAMAGE TO THE
ELECTRONICS AND VOID THE WARRANTY.
1.
2.
3.
4.
Setup
Figure 3 Ocu-Film Tip Cover Placement
Ocu-Film Tip Cover - Too Tight
Ocu-Film Tip Cover - Too Loose
Ocu-Film Tip Cover - Correct