Installation Guide

PARTS INCLUDED
MATERIALS AND TOOLS INSTALL DOOR
INSTALLATION INSTRUCTIONS
for Interior Bifold Doors
2
(5)
#8 x 1-1/4"
at head
track screws
(1)
#8 x 1-3/4"
Truss head
knob screw
(2)
#8 x 5/8"
pan head lower
bracket (jamb)
screws
(1)
#8 x 1-1/4"
pan head lower
bracket (oor)
screw
(3)
#8 x 1/2"
at head screws
(2 aligner,
1 joiner)
Wood
Concrete
Upper pivot pin Guide for track
Snugger or slide guide
Track with upper pivot pin bracket
Track bracket (joiner)
Lower pivot pin
OR
20 pound kit
snugger
30 pound kit slide guide
OR
OR
OR
OR
Lower pivot
bracket
KnobAligner
(used on double
sets only)
NEEDED MATERIALS AND TOOLS
• Measuring tape
• Hammer
• Drill with bits
• #2 Phillips screwdriver
• Safety glasses
• Finishing supplies
INSTALLATION
1. Using a hammer,
gently tap pivot pins
and guide into the
pre-drilled holes in the
locations shown.
2. Position overhead track
in the opening with the
open side down and
the bracket end toward
the jamb. Center the
track in the nished
opening, or allow at
least 3/4" between the
track and the front of
the nished opening.
Secure the track with
the #8 x 1 1/4" at
head screws through the pre-drilled holes until snug. If installing four
panels with two tracks, use a track bracket between the two ends in
the center.
3. Position the lower
bracket on the oor
in line with overhead
track. The bottom of
the bracket must rest
securely on the oor or
carpet. Fasten to the
jamb and oor with
the provided screws as
shown.
4. Place the upper pivot
pin in the hole in the
bracket and the guide
in the track (or in the
middle of the slide
guide between the
springs). Lift the door
assembly slightly and
drop the lower pin into
the lower bracket slot.
5. Verify there is a 1/4"
clearance between
the pivot door and
the jamb. Four panel
assemblies should be
snug at the middle. If
adjustments are necessary, door panels should be folded, in some
cases removed, to gain access to the adjustment screws.
Guide
Upper
pivot pin
Jamb
side
Lower pivot pin
Lower
bracket
Jamb
Floor
Bracket
Pin
Horizontal
adjustment
screw
1/4"
Lead
door
Pivot
door
#8 x 5/8"
pan head
#8 x 1-1/4"
pan head