Installation Guide

Included in this package:
5 Long Screws
4 Short Screws
1 Top Track
1 Bottom Track
2 Sliding Mirror Doors
Bumper Pads
Tools Required:
Drill (optional)
Phillips Screwdriver
Hacksaw
Tape Measure
Step One
A: Trim Track to Fit Opening (if
necessary)
Cut the Fascia Track and Bottom Track
1/16“ (2mm) shorter than the opening width
with a fine tooth hacksaw.
B: Attach Top Track
Using the long screws,
screw in Fascia Track to
header, locating front
edge 1/16“ (2mm) back
from jamb face as shown.
1/16“
(2mm)
C: Attach Bottom
Track
Locate leading edge of
floor track 13/16“
(21mm) back from front
face of jamb so doors
hang plumb. Use the
short screws for the
bottom track.
13/16“
(21mm)
Step Two
A: Install Doors
o
Tilt the door at a 20 angle; insert the
top wheels of the door into the rear
channel of fascia track and allow the
door to hang vertical. Snap bottom
guides into the rear groove of the
bottom track using a screwdriver as
shown. Repeat for the front door.
Step Three
A: Adjust Doors
For vertical
adjustment and
plumb doors, use a
Phillips screwdriver
to adjust the top
rollers as shown.
Cross Sectional Layout
of Installed Doors
3/8“ (10mm) min.
1 3/8“(35mm) max.
13/16“
(21mm)
4“ (100mm) min.
to shelving
1 3/16“ (30mm) min.
2 1/2“(64mm) max.
Bumper Pad