Pivot Door Installation Instructions 12089 Page 1 of 8
Pivot Door Installation Instructions LIMITED LIFETIME WARRANTY Renin Corp. warrants all components for its pivot doors against defects in workmanship and materials subject to ordinary wear and tear, for the life of these products. This includes panel components, tracks, guides & rollers and hardware.
Pivot Door Installation Instructions NOTES: Wear Safety Goggles Units are in Inches. Millimeters are shown in brackets.
Pivot Door Installation Instructions STEP 1 – Prepare Track for Mounting Insert components as shown in Figure 1 for 2-Door set. Tighten Upper Pivot with a Phillips screwdriver as shown in Figure 2. Figure 1 2-DOOR Figure 2 UPPER PIVOT LOCATION TIGHTEN TIGHTEN STEP 2 – Mount Track Mount Track to header as shown below for Fascia to be flush with front of closet. From side to side, center the Track in the opening. Use 5 EA (Max) Screws to mount track.
Pivot Door Installation Instructions STEP 3 – Fasten Mount Plates Fasten Mount Plates as shown below. Mount plates according to the direction of door swing; right swing or left swing. STEP 4 – Mount Lower Jamb Pivot Mount the Lower Jamb Pivot by placing it directly under the track on the pivot side as shown in Figure 3 below. Fasten with one Screw in the slot first and adjust up & down to give clearance between Lower Jamb Pivot & the bottom of the door as shown.
Pivot Door Installation Instructions STEP 5 – Hang Doors by Inserting Bolts into Mount Plates First insert the bolt in the Upper Pivot into the Mount Plates and lock into place by twisting the nylon arm as shown in Figures 4 & 5 below. Figure 5 SWING NYLON ARM TO LOCK Figure 4 BOLTS INTO MOUNT PLATES STEP 6 – Attach at Bottom Pivot Attach Bottom Pivot into Lower Jamb Pivot as shown in Figure 6 below.
Pivot Door Installation Instructions STEP 7 – Check Operation, Make Adjustments If necessary use the Wrench supplied to adjust the bolts in the Upper Pivot to assure the pivot door set is hanging square in the opening. The Lower Jamb Pivot can be adjusted with a Phillips screwdriver. Arrows in Figure 7 below show directions of adjustments. Figure 7 AREAS OF AJDUSTMENT STEP 8 – Magnetic Catches Assemble Magnets to Bracket as shown.
Pivot Door Installation Instructions STEP 9 – Attach Fascia For 2-Door Installs: Attach Fascia to Track by removing the tape backing and pushing against track. Cut Fascia to fit if necessary. Figure 8 ATTACH 2-DOOR FASCIA STEP 10 – Attach the Pull Attach the Pull by drilling a 3/16” [5mm] diameter hole on the inside stile closest to the opening side 36” from the bottom of the door and 1-1/2” from the vertical edge of the stile. Attach the Pull with the Machine Screw as shown in Figure 9 below.