Installation Guide

Included in this package:
5 Long Screws
4 Short Screws
1 Top Track
1 Bottom Track
2 Sliding Mirror Doors
2 Mirror Pulls (w/Frameless door only)
Bumper Pads
Tools Required:
Drill (optional)
Phillips Screwdriver
Hacksaw
Tape Measure
Step One
Trim Track to Fit Opening (if necessary)
Cut the Top “E” Channel and Bottom Track 1/16” (2mm) shorter than
the opening width with a fine tooth hacksaw.
2x4 Blocks
1/16“
(2mm)
Step Two
Attach Top Track
Using the long screws,
screw in “E” Channel to
header, locating front
edge 1/16“ (2mm) back
from jamb face as shown.
Step Three
Attach Bottom Track
Locate leading edge of
floor track 7/8“ (22mm)
back from front face of
jamb so doors hang
plumb. Use the short
screws for the bottom
track.
7/8“
(22mm)
Step Four
Install Doors
To protect the bottom rail, extend the
bottom rollers 1/2“ (12mm) before
installing (as shown in Step Three).
Tilt the door at an angle, inserting the
top of the door into the rear channel
first. Snap the bottom rollers into the
rear groove of the bottom track.
Repeat for the front door.
Step Five
A: Adjust Doors
For vertical
adjustment and
plumb doors, use
a phillips
screwdriver to
adjust the bottom
rollers as shown.
1/2“ (13mm)
For Frameless Doors
only:
B: Attach Mirror Pulls
Clean the mirror where the pull
will be positioned,
(
Peel off the
tape protection and press the
pull firmly on the mirror. Once
applied, the pull can not be
re-positioned.
approximately 40“ (101 cm),
1/2” (1.3cm) in from the door’s
outside edge).
Cross Sectional Layout
of Installed Doors
3/8“ (10mm) min.
1 3/8“(35mm) max.
7/8“
(22mm)
Bumper Pad
3/8“ (10mm) min.
1 5/8“(41mm) max.