Installation Guide

ManualsBrandsReliaBilt ManualsBarn Doors8512068WHWL

9852 Series Wall Sliding Door

ILLUSTRATION OF PARTS BREAKDOWN

Installation Instructions

Chaparral –A Division of KLS Doors 501 Kettering Drive, Ontario, CA 91761

ITEM

NO.

PART NO. DESCRIPTION QTY.

1 8201 TRACK 1

2 9850 DOOR PANEL 2

3 CHH-436 END CAP, LEFT 1

4 CHH-438 END CAP, RIGHT 1

5 CHS-58

#8 X 1-1/2" WASHER HEAD SELF

DRILLING SCREWS

6 CH32-076-000 TOP ROLLER ASSEMBLY 4

7 CHS-60

#8-32 X 5/16" SELF TAPPING PAN HEAD

SCREW

8 CHH-446 BOTTOM GUIDE 2

9 CHS-44

#6-32 X 1-1/4" PAN HEAD SCREW 4

10 CHH-530 L BRACKET 2

11 CHS-45 #6 SQUARE NUT 4

12 CHH-440

(Optional Special Order) HANDLE 4

13 CH43-019 WRENCH 1

FRAMEWORK:

HARDWARE BAG:

Summary of content (4 pages)

PAGE 1
9852 Series Wall Sliding Door Installation Instructions ILLUSTRATION OF PARTS BREAKDOWN 11 11 1 4 3 9 5 9 6 12 2 2 7 7 8 5 8 10 10 ITEM NO. PART NO. FRAMEWORK: 1 8201 2 9850 HARDWARE BAG: 3 CHH-436 4 CHH-438 5 6 7 8 9 10 DESCRIPTION QTY.
PAGE 2
Wall Sliding Door 9852 Series 1. TOOLS REQUIRED FOR INSTALLATION: Pencil Tape Measure Stud Finder No. 2 Phillips tip screwdriver, Drill w/ No. 2 Phillips tip & 3/16” Metal Drill Bit Wall Anchors (Not Included) Level Roller Bracket Wrench (Included) Safety Goggles (Recommended) IMPORTANT: Before beginning installation, read instructions thoroughly and carefully. Installation may require the need for anchors and/or additional screws that are not included in this package.
PAGE 3
9852 Series Wall Sliding Door 4. 5. HORIZONTAL LINE FASTEN T RACK TO S HORIZONTAL LINE TUDS #8 X 1-½ WASHER HEAD SCREW WALL SCORED LINE 3/16 HOLES . A. Attach the top track to the wall using #8 x 1-1/2 washer head screws (Item #5). A. Place the track in position (top edge of the track on the horizontal line and centered on the vertical line). Transfer the stud lines to the track and pre-drill the track along the scored line with a 3/16 drill bit. 6. B.
PAGE 4
9852 Series Wall Sliding Door 8. 9. (A) BOTTOM GUIDE EXAMPLE A (C) (B) (D) A. Center the door in front of the bottom guide. B. Insert the top of the door under the track. C. Place the door over the bottom guide. EXAMPLE B D. Lower the door over the bottom guide. 10. 11. ROLLER BRACKET #6 PAN HEADS #6 SQUARE NUT A. Engage the top rollers into the roller brackets at both ends. B.