Installation Guide

A. Place the track in position (top edge of the
track on the horizontal line and centered
on the vertical line). Transfer the stud lines
to the track and pre-drill the track along the
scored line with a 3/16 drill bit.
.
HORIZONTAL LINE
SCORED LINE
3/16 HOLES
4. 5.
6.
9852 Series Wall Sliding Door
A. Position the L-Bracket (Item #10) on the wall or
baseboard.
B. Align the vertical edge of the L-Bracket with
the vertical edge of the wall as shown and
fasten it the L-Bracket with two #8 X 1-1/2
Washer Head Screws (Item #5).
C. Leave about a 1/8 gap between the floor and
the bottom of the L-Bracket.
WALL
HORIZONTAL LINE
#8 X 1 WASHER HEAD SCREW
A. Attach the top track to the wall using #8 x 1-1/2
washer head screws (Item #5).
B. If the end of the track does not land on a stud then use
a wall anchor to secure that end.
A. If the L-Bracket is attached directly to the wall; using a
Phillips head screwdriver attach the bottom guide
(Item #8) to the L-Bracket using two #8-32 5/16 Self
Tapping Pan Head Screws (Item #7) by inserting the
screws into the holes that are furthest from the wall.
(REFER TO STEP 8 EXAMPLE A)
B. If the L-Bracket is attached to a baseboard use the
holes that are closest to the wall. (REFER TO STEP
8 EXAMPLE B)
REFER TO
NOTE B
REFER TO
NOTE A
7.
FASTEN TRACK TO STUDS