Installation Guide

Step 1. Door Preparation

Note, a second optional wall-mounted door guide has

also been provided in this kit should you not wish to

mortise your door.

Mortise 1/4" wide x 3/4" deep groove centrally to the bottom

of the door for use with the oor-mounted door guide. This

will ensure smoothness of door travel side-to-side and will

prevent the door from swinging in and out.

If you prefer, you can also have your door mortised at the store

you have purchased your door (typically, for an additional

charge). See your store for details.

3/4" (19mm)

1/4"

(6.3mm)

Step 3. Door Preparation – Anti-jump block Installation

Position each anti-jump block at least 1" from the edge of the

Straps. Tighten slightly to secure in place.

Step 2. Door Preparation – Strap Installation

Position each Strap a minimum of 4" from the edge of the

door and 1.5" from the top of the door.

With the strap in place, mark the rst hole with a pencil and

then secure screw into place. Position and secure the screw

into place for the second hole. Repeat for second strap.

Should pilot holes be necessary, typically for softwood pre-

drill a hole 3/32" and for hardwood pre-drill a hole 1/8".

4" (101mm)

BD101K-07800 / BD101K-09600 INSTALLATION GUIDE

BARN DOOR HARDWARE TOP OF DOOR STRAP KIT

renincorp.com