Use and Care Guide

Framed Bottom Roll Sliding Door
Included in this package:
8 Long Screws
6 Short Screws
1 Top Track
1 Bottom Track
2 Sliding Mirror Doors
Bumper Pads
Tools Required
Drill (optional)
Phillips Screwdriver
Hacksaw
Tape Measure
Step One
Trim Track to Fit Opening
(if necessary)
Cut the Top “E” Channel
and Bottom Track 1/16”
(2mm) shorter than the
opening width with a fine
tooth hacksaw.
2x4 Blocks
1/16“
(2mm)
Step Two
Attach Top Track
Using the long screws,
screw in “E” Channel to
header, locating front
edge 1/16“ (2mm) back
from jamb face as shown.
Step Three A
Attach Bottom Track (Without Carpet):
Locate leading edge of floor track 7/8“
(22mm) back from front face of jamb so
doors hang plumb. Use the short screws for
the bottom track.
7/8“
(22mm)
Step Four
Install Doors
To protect the bottom rail, extend the
bottom rollers 1/2“ (12mm) before
installing (as shown in Step Five). Tilt
the door at an angle, inserting the top
of the door into the rear channel first.
Snap the bottom rollers into the rear
groove of the bottom track. Repeat for
the front door.
Step Five
Adjust Doors
For vertical adjustment and
plumb doors, use a phillips
screwdriver to adjust the
bottom rollers as shown.
Cross Sectional Layout
of Installed Doors
3/8“ (10mm) min.
1 3/8“(35mm) max.
7/8“
(22mm)
Bumper Pad
3/8“ (10mm) min.
1 5/8“(41mm) max.
FRONTFRONT
88151
Step Three B
Attach BottomTrack (With Carpet):
Place 2” wide x length of bottom track x
1/8” thick (min) strip of plywood on top of
carpet as shown.
Wood Strip