User Manual

NOTE:
As soon as the Time or Ratio buttons have been activated, the Scratch mode
is temporarily deactivated.
TIP:
The Echo effect sounds best if synchronous with the beat. Ideally, use the
Beat link buttons -36- to vary the length of the effect.
33. Flanger button
Use the Flanger button -33- to activate the flanger effect. This frequently
applied effect is similar to the Phase effect, but slightly more harmonious,
emphasises the upper pitch more and is reminiscent of a flying aircraft.
Your device synchronises the effects automatically with the current BPM
value. Use the Beat link buttons-36- to precision-set the frequency.
To manually change the beat frequency of the effect, press the Parameter
Time Button -25- and regulate the frequency value with the Jog Wheel (from
0 - 9990 mSec.).
To influence the intensity of the effect, press the Parameter Ratio button -26-
and set the volume with the Jog Wheel (from 0 - 255).
NOTE:
As soon as the Time or Ratio buttons have been activated, the Scratch mode
is temporarily deactivated.
TIP:
The Flanger effect is best when set to 4/1 beat with the beat link button.
34.Trans button
Use the Trans button -34- to activate a Cut effect. This effect sounds as if
cutting the signal quickly with the cross fader.
Your device synchronises the effects automatically with the current BPM
value. Use the beat link buttons -36- to change the frequency to match the
beat.
To manually change the beat frequency of the effect, press the Parameter
Time button -25- and regulate the frequency value with the Jog Wheel (from
0 - 9990 mSec.).
To influence the intensity of the effect, press the Parameter Ratio button -26-
and set the volume with the Jog Wheel (from 0 - 255).
NOTE:
As soon as the Time or Ratio buttons have been activated, the Scratch mode
is temporarily deactivated.
TIP:
This effect should also be varied for optimum results with the beat link
buttons -36-.
32
ENGLISH
IM_RMP2_MK2.qxp 14.01.2009 15:23 Uhr Seite 32