Owner`s manual

5th C O M M A N D M E N T
Use Proper Ammunition
Every firearm is designed to use a certain caliber or gauge of ammunition. Using the wrong ammunition, mixing ammu-
nition or using improperly reloaded ammunition can cause serious personal injury or death. And it only takes one car-
tridge or shotshell of the incorrect caliber or gauge, or which has been improperly reloaded, to destroy your firearm. It's
your responsibility to make sure the ammunition you use exactly matches the caliber or gauge of your gun. Refer to this
instruction book to find out the specific requirements of your firearm. Always read and heed the instructions on ammu-
nition boxes.
Confusing shells or cartridges can cause serious personal injury or death and destroy your firearm. Examine your shells
or cartridges closely and use only the precise caliber or gauge for your specific firearm. For example, suppose you acci-
dentally loaded a 20 ga. shell into a 12 ga. shotgun. Because the 20 ga. shell is too small for the chamber, the 20 ga.
shell could travel down the barrel and get lodged in the bore. If you then loaded a standard 12 ga. shell behind it and
fired, the 12 ga. shot will slam into the lodged 20 ga. shell and may cause the barrel to explode right in your hand. This
is commonly called a 12/20 burst, and it can kill you.
Check all ammunition before you load it to make sure it matches your gun's requirements. Every Remington
®
cartridge
and shell is head-stamped with its caliber or gauge for easy identification. Likewise, you'll find the caliber or gauge of
your new Remington firearm imprinted on the barrel.
Reloading Requires Extra Diligence.
If you're an ammunition reloader, you are responsible for personally assuring that the loads and components of your
reloaded ammunition meet your gun's factory-tested standards. Never use ammunition, which has been reloaded by
someone else!
Many shooters handload as a hobby or to save money on commercial, factory-made ammunition. However, it requires
a thorough knowledge of reloading procedures and a deep respect for the explosive potential of gunpowder.
Firearms are designed, manufactured and proof-tested to standards based on factory-loaded ammunition.Handloaded
or reloaded ammunition that deviates, either intentionally or accidentally, from load or component recommendations can
be very dangerous.
Reloaders must observe all possible safety precautions and practices related to the proper handling of explosives.
Whether you're a seasoned reloader or just starting out, you should study the subject, watch reloading demonstrations
and talk to experienced reloaders.
The first rule of reloading is to always follow the manufacturer's instructions for the components you're using. They'll
tell you to follow certain guidelines. Namely:
1. Don't mix or substitute powders or primers.
2. Don't use unknown or substandard components.
3. Use only suitable components that have been factory-tested by reputable ammunition,
powder and bullet manufacturers.
4. Always be sure to use the manufacturer's recommended recipe when reloading.
Not following these guidelines could result in severe injury to yourself or severe damage to your firearm. Dangerously high
pressure and explosions can result from an overcharge of powder or other deviations from established reloading guidelines.
Be very careful. The process of reloading exposes you to environmentally hazardous material. Lead, which is known to cause
cancer and birth defects, is the most common substance in bullets and shot. It is important to handle lead bullets and shot
with extreme care. Work only in a well-ventilated area and always wash your hands after exposure and before eating. Never
smoke while reloading.
Primers and powders are also highly toxic and flammable. So after reloading be sure to clean up all materials from your
work area. Don't leave primer or powder spills anywhere on the floor or bench top. Dispose of all waste material in accor-
dance with the manufacturer's recommendations.
Finally, when reloading or handloading concentrate on what you're doing at all times. Do not be distracted by talking to
others, listening to the radio or watching TV while reloading. Never reload after consuming alcoholic beverages or drugs
of any kind. You are working with extremely hazardous materials and you can't risk even a few seconds of distraction.
Remember, if you reload, you are the ammunition manufacturer and you are responsible for the performance and safe-
ty of your reloaded ammunition.
4
6th C O M M A N D M E N T
IF YOUR GUN FAILS TO FIRE WHEN THE TRIGGER IS PULLED, HANDLE WITH CARE.
I f for some reason the ammunition doesn't fire when you pull the trigger, stop and remember the 1st
Commandment of Firearm Safety - always keep the muzzle pointed in a safe direction. Keep your face away from
the breech, then put the safety on, carefully open the action, unload the firearm and dispose of the cartridge safe-
ly. Remember that anytime there's a shell in the chamber, your gun is loaded and ready to use. Even if you tried
to shoot and your gun didn't fire, treat your firearm as if it could still discharge.
7th C O M M A N D M E N T
Your sight and hearing risk injury from shooting and should be protected at all
times. Wear protective shooting glasses to guard against falling shot, clay target
chips, powder residue, ruptured cartridge cases and even twigs and branches in
the field. Also be sure to wear eye protection when you're disassembling or clean-
ing a gun so that tensioned parts (like springs) and cleaning solvents don't come
in contact with your eyes. Continued exposure to shooting noise can permanently
damage your hearing. On the range, where shooting volume is the loudest, be sure to use the maximum pro-
tection of a headset. And learn to use ear protection in the field, especially in confined locations like duck
blinds.
8th C O M M A N D M E N T
BE SURE THE BARREL IS CLEAR OF OBSTRUCTIONS BEFORE SHOOTING.
Before loading your gun , open the action and make sure there's no ammunition in the chamber or magazine.
Check the barrel for any obstructions or debris. Even a small amount of snow, mud, excess lubricant or grease
in the bore can dangerously increase pressure and cause the barrel to bulge or burst when firing. Use a clean-
ing rod and patch to wipe away anti-rust compounds or any other residues or obstructions in the barrel. Never
try to shoot out an obstruction by loading another shell and firing!
When firing , rely on your instincts. If the noise or recoil of your firearm seems weak, stop everything, unload
your firearm and be sure nothing is lodged in the barrel. Remember the 12/20 burst? That's what can happen
when the barrel is obstructed. So always be sure you're using the correct ammunition in your firearm and that
it's free of obstructions.
9th C O M M A N D M E N T
DON'T ALTER OR MODIFY YOUR GUN AND HAV E I T SERVICED REGULARLY.
Your firearm has been designed to operate according to certain factory specifications. You'll jeopardize your
safety and that of others around you by attempting to alter its trigger, mechanical safety or other mechanisms.
So never alter or modify your firearm in any way.
Like any mechanical device, a firearm is subject to wear. It must be main-
tained and periodically serviced to assure optimum safety and performance.
Only a qualified service facility should service, repair or modify your
Remington® firearm. Consult your instruction book for instructions on how
to send your firearm to the factory or for the location of the nearest
Remington repair station.
Proper cleaning and lubrication are also important to firearm maintenance
and are necessary to assure accuracy, safety and reliability. Before cleaning,
always make sure that your gun is completely unloaded. And always clean the
barrel from the chamber end to the muzzle when possible.
Make it a practice to clean your bore every time you're going to shoot. Be sure to clean your entire gun before and
after long-term storage and no less than once a year. It's also important to clean your gun whenever it's been
exposed to adverse conditions such as rain, dirt, mud, snow, sleet or saltwater.
ALWAYS WEAR EYE AND EAR PROTECTION WHEN SHOOTING.
5
e5762remington_Q6.qxp 9/25/09 11:06 AM Page 3