Specifications

12
Scene Control
Z-Wave Scenes are used for setting up multiple devices in the same
way as a group but in addition to groups, scenes also control dimmer
lights that you can set to different levels depending on the situation.
For example you can have the scene set to low brightness for watching
a movie or going to bed or alternatively set the lights brighter when
reading or working. After the scene has been programmed it will work
with the corresponding ON OFF key on the top side of the remote.
You can control up to 16 scenes (Scene On/Off) with your Z-URC
TM
550EU. Each Scene supports up to 32 Z-Wave devices or End-point
(EP) and supports up to 232 Z-Wave devices in a network.
Remark: There are total 16 groups of on/off keys which are shared by
Scene and Group, for example, if you used 6 groups as Group, there
are 10 groups on/off keys left for Scene, and vise versa.
Scene Setup
Adding Device/End-point to a Scene
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK＂ light turns
on
2
Press
• “OK＂ LED flashes
once and stays on
• “LED_A＂ flashes
slowly
3
Select a scene number
from 1 to 16 (1-8 or
1-8)
• “OK＂ LED flashes
once and stays on
• “LED_A＂ off
• “LED_B＂ flashes
slowly
4
Press the program/EP
button on the target
device
• “OK＂ LED flashes
once and stays on
• “LED_B＂ keep
blinking slowly
5
Adjust the target device
on/off or dim level with
its program button, to the
desired status
-