Specifications
13
6
Press
• “OK" LED flashes
once then turns off
• “LED_B" off
• The current status of the
device will be learned
and saved to a scene
successfully
Note 1: Your target device must be included in the network before this
setup procedure, please refer to [Adding Device to the Network]
section.
Removing Device/End-point from a Scene
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK" light turns
on
2
Press
• “OK" LED flashes
once and stays on
• “LED_A" flashes
slowly
3
Select a scene number
from 1 to 16 (1-8 or
1-8)
• “OK" LED flashes
once and stays on
• “LED_A" off
• “LED_B" flashes
slowly
4
Press the program/EP
button on the target
device
• the “OK" light stays
on then flashes once and
turns off
• “LED_B" off
• Device removed from the
scene successfully
Note 1: This process will only remove the target device/EP from its
assigned scene but will not exclude it from the network.
Deleting a Scene
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK" light turns
on
2 Press
• “OK" LED flashes
once and stays on