Specifications
17
Assign Association for Two Devices
The Z-URC
TM
550EU can be used to assign one device to
automatically interact directly with another device.
For example you can assign a door sensor (primary node) to turn on the
light switch (secondary node) when the door is opened.
Adding Device/End-point to an Association Group
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK" light turns
on
2
Press
• “OK" LED flashes
once and stays on
• “LED_A" flashes
slowly
3
Select a group number
from 1 to 16 (1-8 or
1-8)
• “OK" LED flashes
once and stays on
• “LED_A" off
• “LED_B" flashes
slowly
4
Press the program/EP
button on the secondary
device (e.g. light switch)
• “OK" LED flashes
once and stays on
• “LED_B" flashes once
and keep blinking slowly
5
Press the program/EP
button on the primary
device (e.g. door sensor)
• “LED_B" turns off
• “OK" LED flashes
once then turns off
• Assigning association
completed
Note 1: Your target device must be included in the network before this
setup procedure, please refer to [Adding Device to the Network]
section.